libgcc +universal build failure

[joy.757@…]

I was trying to install gcc5 +universal (having set universal_archs) in order to be able to use -m32. I got the following error:

--->  Fetching distfiles for libgcc
--->  Verifying checksums for libgcc
--->  Extracting libgcc
--->  Applying patches to libgcc
--->  Configuring libgcc
--->  Building libgcc
 Error: org.macports.build for port libgcc returned: command execution failed
Please see the log file for port libgcc for details:
    /opt/local/var/macports/logs/_opt_local_var_macports_sources_distfiles.macports.org_ports_lang_gcc5/libgcc/main.log
To report a bug, follow the instructions in the guide:
    http://guide.macports.org/#project.tickets
Error: Processing of port libgcc failed

Also tried to install just libgcc and got the same error. The logs mentioned in the error message (for gcc5 as well as libgcc) is attached.

[joy.757@…]

The commands i ran were:

sudo port install gcc5 +universal

and later

sudo port install libgcc +universal

Also, after running

sudo port clean libgcc

I freed up 4+ GB of space. Not sure if that's normal or has anything to do with the problem.

[mf2k (Frank Schima)]

In the future, please fill in the Port field with the port that actually fails to build and Cc that port's maintainers (port info --maintainers libgcc), if any.

[joy.757@…]

It's working fine now. I managed to compile properly. I think the problem was caused by running out of hard disk space, since it ran fine after freeing ~10 GBs.

[ryandesign (Ryan Carsten Schmidt)]

I've replaced your enormous attachments with compressed versions of them.

Both of the logs you attached are build failures of the libgcc port, and they both say:

fatal error: can't write PCH file: No space left on device

This means your disk was full.